Practical Electronics/Circuits Analysis/Superposition

Superposition Principle

(a)

(b)

(c)

Figure 1: The circuits showing the linearity of resistors.

Most basic electronic circuits are composed of linear elements. Linear elements are circuit elements which follow Ohm’s Law. In Figure 1 (a) with independent voltage source, V₁, and resistor, R, a current i₁ flows. The current i₁ has a value according to Ohm’s Law. Similarly in Figure 1 (b) with independent voltage source, V2, and resistor, R, a current i₂ flows. In Figure 1 (c) with independent voltage sources, V1 and V2, and resistor, R, a current i flows. Using Ohm’s Law equation 1 is reached. If some simple algebra is used then equation 2 is reached. But V₁/R has a value i₁ and the other term is i₂ this gives equation 3. This is basically what the Superposition Theorem states.

$i={\frac {V_{1}+V_{2}}{R}}$(1)

$i={\frac {V_{1}}{R}}+{\frac {V_{2}}{R}}$(2)

$i=i_{1}+i_{2}\,$(3)

The Superposition Theorem states that the effect of all the sources with corresponding stimuli on a circuit of linear elements is equal to the algebraic sum of each individual effect. Each individual effect is calculated by removing all other stimuli by replacing voltage sources with short circuits and current sources with open circuits. Dependent sources can be removed as long as the controlling stimuli is not set to zero. The process of calculating each effect with one stimulus connected at a time is continued until all the effects are calculated. If kth stimulus is denoted sk and the effect created by sk denoted ek.

$\sum _{k=1}^{N}e_{k}$(4)

The steps for using superposition are as follows:

1. Calculate the effect of each source in turn with all other independent voltage sources short circuited and independent current sources open circuited.

2. Sum these effects to get the complete effect.

Note: the removal of each source is often stated differently as: replace each voltage source with its internal resistance and each current with its internal resistance. This is identical to what has been stated above. This is because a real voltage source consists of an independent voltage source in series with its internal resistance and a real current source consists of a independent current source in parallel with its internal resistance.

Superposition Example

Figure 2: The circuit for the example.

Problem: Calculate the voltage, v, across resistor R₁.

Step 1: Short circuit V₂ and solve for v₁. By voltage divider rule.

$v_{1}={\frac {V_{1}(R_{1}||R_{3})}{R_{2}+(R_{1}||R_{3})}}$(5)

Short circuit V₁ and solve for v₂. By voltage divider rule.

$v_{2}={\frac {V_{2}(R_{1}||R_{2})}{R_{3}+(R_{1}||R_{2})}}$(6)

Step 2: Sum the effects.

$v=v_{1}+v_{2}\,$

Using equations 5 and 6.

$v={\frac {V_{1}(R_{1}||R_{3})}{R_{2}+(R_{1}||R_{3})}}+{\frac {V_{2}(R_{1}||R_{2})}{R_{3}+(R_{1}||R_{2})}}$

If $R_{1}=R_{2}=R_{3}=2k\Omega$ and $V_{1}=V_{2}=15V$ then

$v={\frac {15(2k||2k)}{2k+(2k||2k)}}+{\frac {15(2k||2k)}{2k+(2k||2k)}}$

$v={\frac {15(1k)}{3k}}+{\frac {15(1k)}{3k}}$

$v=10V\,$